Search results for: 'female+hdmi+to+female'

MPO/MTP Loop Back.

MPO/MTP Loopback are used widely within testing environment especially within parallel optics 40 and 100G networks. Devices allow verification and testing of transceivers featuring MPO/MTP interface - 40G BASED-SR4 QSFP+ or 100G BASE-SR10 CXP/CFP devices. Loopbacks are built to link Transceivers (TX) and Receivers (RX) positions of MPO/MTP transceivers interfaces. MPO/MTP loopbacks can facilitate and speed up IL testing of optical networks segments by connecting them to MPO/MTP trunks/patch leads.

See PDF Download For More Information.

IEC (C14) to IEC Lock Plus (C13) Black.

• CAT3 RJ21 Male Telco Breakout to 24 RJ45 Plugs.
• pins 4 & 5
• UK manufactured and 100% tested
• Available with 90 degree, 120 degree and 180 degree hoods
• Other lengths can be manufactured to order

RJ21 Cat3 25pair Telco cable

180 degree male connector with Bail Lock to Open end telco cable

Bail lock notches at the sides are for the female connector that's normally on a piece of equipment.

CAN MANUFACTURE TO ANY LENGTH REQUIRED - PLEASE CALL FOR ASSISTANCE.

180 degree male connector with Bail Lock to 3 x 237a krone strips. 

Bail lock notches at the sides are for the female connector that's normally on a piece of equipment.

CAN MANUFACTURE TO ANY LENGTH REQUIRED - PLEASE CALL FOR ASSISTANCE.

MPO MicroCable Trunk Assembly.

MPO MicroCable Trunks facilitate rapid deployment of high density backbone cabling in data centers or other high fiber density environments reducing network installation or reconfiguration time and cost. They are used to interconnect cassettes, panels or ruggedised MPO Fan Outs, spanning MDA, HDA and EDA zones.

See PDF Download For More Information.

• CAT3 RJ21 Male Telco Breakout to 24 RJ11 Plugs.
• UK manufactured and 100% tested
• Available with 90 degree, 120 degree and 180 degree hoods
• Other lengths can be manufactured to order

MPO MicroCable Fan-Out Assembly.

MPO Fan-Out Assemblies interface multifiber MPO with discrete single fiber (LC/SC) connectors. Assemblies are typically used to directly interconnect MPO  cassettes, panels or backbone trunk assemblies with the active equipment ports, saving costly data center rack space and easing fiber management. Replacing traditional MPO  module Fan-Out Assemblies reduce amount of interconnection improving power budget cost effectiveness.   

See PDF Download For More Information.

CXP/CFP 100G MPO Cable Assembly.

CXP/CFP 100G MPO/MTP® cable assemblies are designed to make a connection between 2 CFP/CXP transceivers. They are built using 24 fiber ferrule MPO/MTP  connectors with custom fiber mapping polarity to provide connection between 100GBASE-SR10 CFP/CXP devices.

See PDF Download For More Information.

MPO MicroCable Patch Assembly (Single Jacket 3mm OD).

MPO MicroCable Patch assemblies facilitate rapid deployment of high density cabling in data centers or other high fiber density environments reducing network installation or reconfiguration time and cost. They are typically used for patching within MDA zone or interconnect MPO active equipment ports with backbone cabling.

See PDF Download For More Information.